 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove three screws and washers from PDP.
(3)
Remove three screws from PDP.
(4)
Lift PDP outward to gain access.
(5)
Disconnect connector J27 from connector P27.
(6)
Set multimeter to volts dc.
(7)
Connect positive (+) probe of multimeter to
connector J27-4.
(8)
Connect negative (-) probe of multimeter to
ground.
(9)
Position master power switch to on
(TM 9-2320-366-10-1).
(10)
Press windshield washer switch
(TM 9-2320-366-10-1) and note reading on
multimeter.
(11)
If 24 vdc is not present, repair wire 1424
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(12)
Position master power switch to off
(TM 9-2320-366-10-1).
(13)
Connect connector J27 to connector P27.
(14)
Install PDP on dashboard with three screws.
(15)
Install three washers and screws in PDP.
(16)
Install PDP cover (para 16-2).
2-883
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals