Quantcast CONTINUITY TEST - TM-9-2320-366-20-11387

 

Click here to make tpub.com your Home Page

Page Title: CONTINUITY TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
TRAILER BLACKOUT MARKER LIGHTS DO NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11386
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
TRAILER BLACKOUT MARKER LIGHTS DO NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11388
TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
(1) Remove three screws and washers from
PDP.
(2) Remove three screws from PDP.
(3) Lift PDP outward to gain access.
(4) Disconnect connector J51 from connector
P51.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to relay K29 terminal 87 on PDP.
(7) Connect negative (-) probe of multimeter
to connector J51 pin 10 and note reading
on multimeter.
(8) If continuity is not present, repair wire
484T from relay K29 terminal 87 on PDP
to connector J51 pin 10 (para 2-45) or
replace WTEC II dashboard assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(9) Install relay K29 in PDP.
Change 1
2-823

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.