Quantcast CONTINUITY TEST - TM-9-2320-366-20-11383

 

Click here to make tpub.com your Home Page

Page Title: CONTINUITY TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
TRAILER BLACKOUT MARKER LIGHTS DO NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11382
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
TRAILER BLACKOUT MARKER LIGHTS DO NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11384
TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
(1)
Remove PDP cover (para 16-2).
(2)
Remove relay K29 from PDP.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter
to connector J130 sockets A, C, and H,
one at a time.
(5) Connect negative (-) probe of multimeter
to relay K29 terminal 87 on PDP and note
reading on multimeter.
(6) If continuity is not present, go to step 6
of this fault.
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to relay K29 terminal 30 on PDP.
(3) Connect negative (-) probe of multimeter
to ground.
(4) Position main light switch to BO DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(5) If 24 VDC is not present, repair wire 1958
from K29 terminal 30 on PDP to circuit
breaker CB42 terminal 4 (para 2-45) or
replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-819

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.