Quantcast VOLTAGE TEST - TM-9-2320-366-20-11365

 

Click here to make tpub.com your Home Page

Page Title: VOLTAGE TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
TRAILER RIGHT STOP/TURN LIGHT DOES NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11364
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
TRAILER RIGHT STOP/TURN LIGHT DOES NOT ILLUMINATE (CONT) - TM-9-2320-366-20-11366
TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to relay K31 terminal 86 on PDP.
(3) Connect negative (-) probe of multimeter
to ground.
(4) Position master power switch to on
(TM 9-2320-366-10-1).
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(6) Apply brakes and note reading on
multimeter.
(7) If 12 VDC is not present, repair wire 460B
from relay K31 terminal 86 on PDP to
connector J19 socket 3 (para 2-45) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) Position main light switch to OFF
(TM 9-2320-366-10-1).
(9) Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to relay K31 terminal 85 on PDP.
(3) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(4) If continuity is not present, repair wire
3048 from K31 terminal 85 on PDP to
terminal board TB2 position 53 (para 2-45)
or replace WTEC II dashboard assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(5) If continuity is present, replace relay K31
(para 7-9).
(6) Install relay K31 in PDP.
(7) Install PDP cover (para 16-2).
Change 1
2-801

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.