 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Remove three screws and washers from
PDP.
(2) Remove three screws from PDP.
(3) Lift PDP outward to gain access.
(4) Set multimeter to volts DC.
(5) Connect positive (+) probe of multimeter
to terminal block TB1 position 27.
(6) Connect negative (-) probe of multimeter
to ground.
(7) Position master power switch to on
(TM 9-2320-366-10-1).
(8) Position main light switch to STOPLIGHT
(TM 9-2320-366-10-1).
(9) Apply brakes and note reading on
(10) If 12 VDC is not present, go to step 17
of this fault.
(11) Position main light switch to OFF
(TM 9-2320-366-10-1).
(12) Position master power switch to off
(TM 9-2320-366-10-1).
(13) Install PDP on dashboard with three
screws.
(14) Install three washers and screws in PDP.
(15) Install diode D1A in PDP.
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals