 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes. Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector P88 from RH rear
side marker light connector.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P88.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF (TM
9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
from splice E15 to splice E17 (para 2-45)
and go to step 9 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1 of
this fault.
(8) If 12 VDC is present, repair wire 489 from
connector P89 to splice E17 (para 2-45)
and go to step 46 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1
of this fault.
NOTE
Install plastic cable ties as required.
(9) Connect RH rear side marker
light connector to connector P88.
(10) Connect RH rear marker light connector
to connector P89.
Change 1
2-604.163
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals