Quantcast VOLTAGE TEST - TM-9-2320-366-20-11093

 

Click here to make tpub.com your Home Page

Page Title: VOLTAGE TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
M1085/M1086/M1089/M1096 INTERMEDIATE, SIDE, AND/OR REAR MARKER LIGHT(S) DO NOT ILLUMINATE (cont) - TM-9-2320-366-20-11092
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
M1085/M1086/M1089/M1096 INTERMEDIATE, SIDE, AND/OR REAR MARKER LIGHT(S) DO NOT ILLUMINATE (cont) - TM-9-2320-366-20-11094
TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets wo multimeter probes. Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector P85 from LH rear
side
marker light connector.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P85.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF (TM
9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
from splice E15 to splice E16 (para 2-45)
and go to step 46 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1 of
this fault.
(8) If 12 VDC is present, repair wire 489 from
connector P85 to splice E16 (para 2-45)
and go to step 46 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1 of
of this fault.
NOTE
Install plastic cable ties as required.
(9) Connect LH rear side marker light
connector to connector P85.
(10) Connect LH marker light connector to
connector P86.
Change 1
2-604.161

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.