 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL16,
and lockwasher from LH rear marker light
screw. Discard lockwashers.
(2) Step multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL16.
(4) Connect negative probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair 3094
from terminal lug TL16 to terminal lug
TL18 (para 2-45) and go to step 8 of this
fault if required or replace M1086/M1089
rear lights cable assembly (para 7-104) or
M1085/M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(6) If continuity is present, repair 489 from
splice "A" to splice "B" (refer to Table
2-12.12. M1085/M1086/M1089/M1096
LH Rear Marker Light Splices) (para 2-45)
and go to step 8 of this fault if required or
replace M1086/M1089 rear lights cable
assembly (para 7-104) or M1085/M1096
rear lights cable assembly (para 7-84) and
go to step 1 of this fault.
(7) Install lockwasher, terminal lug TL16,
lockwasher, and nut on LH rear marker
light screw.
Table 2-12.12. M1085/M1086/M1089/M1096
LH Rear Marker Light Splices
Model
Splice "A"
Splice "B"
M1085/M1086/M1096
E15
E16
M1089
E49
E51
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals