 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
If vehicle is not M1089, repair wire 3094 from
terminal lug TL32 to splice E21 (para 2-45)
and go to step 10 of this fault if required or
replace M1086 rear lights cable assembly
(para 7-104) or M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1 of this
fault.
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL30,
and lockwasher from LH rear marker light
screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL30.
(4) Connect negative (-) probe of multimeter to
to ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3094 from terminal lug TL30 to terminal
lug TL92 (para 2-45) and go to step 10 of
this fault if required or replace M1089 rear
lights cable assembly (para 7-104) and go
to step 1 of this fault.
(6) If continuity is present, repair wire 489
from splice E49 to splice E50 (para 2-45)
and go to step 10 of this fault if required or
replace M1089 rear lights cable assembly
(para 7-104) and go to step 1 of this fault.
(7) Install lockwasher, terminal lug TL30,
lockwasher, and nut on LH rear marker
light screw.
Change 1
2-604.119
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals