CONTINUITY TEST - TM-9-2320-366-20-10979

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug TL16

and lockwasher from LH marker light screw.

(2) Connect positive (+) probe of multimeter to

terminal lug TL16.

(3) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(4) If continuity is not present, repair wire 3094

from terminal lug TL16 to terminal lug TL18

(para 2-45) and go to step 30 of this fault if

required or replace rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(5) If continuity is present, replace LH marker

light (para 7-38) and go to step 31 of this

fault if required.

(6) Install lockwasher, terminal lug TL16,

lockwasher, and nut on LH marker light

screw.

(7) Connect LH marker light connector to

connector P86.

Change 1

2-604.47