CONTINUITY TEST - TM-9-2320-366-20-10969

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug TL20

and lockwasher from RH rear marker light

screw. Discard lockwashers.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter to

terminal lug TL20.

(4) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire 3095

from terminal lug TL20 to terminal lug TL21

(para 2-45) and go step 6 of this fault if

required or replace rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(6) If continuity is present, repair wire 489 from

splice E15 to splice E17 (para 2-45) and

go to step 6 of this fault if required or

replace rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(7) Install lockwasher, terminal lug TL20,

lockwasher, and nut on RH rear marker

light screw.

Change 1

2-604.37