CONTINUITY TEST - TM-9-2320-366-20-10961

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug TL16

and lockwasher from LH rear marker light

screw. Discard lockwashers.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter to

terminal lug TL16.

(4) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire 3094

from terminal lug TL16 to ground

(para 2-45) and go to step 5 of this fault or

replace rear lights cable assembly (para 7-84)

and go to step 1 of this fault.

(6) If continuity is present, repair wire 489 from

splice E15 to splice E16 (para 2-45) and

go to step 5 of this fault if required or

replace rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(7) Install lockwasher, terminal lug TL16,

lockwasher, and nut on LH rear marker

light screw.

Change 1

2-604.29