 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Loosen four captive screws in lamp mounting
panel.
(2)
Remove lamp mounting panel from lighted
indicator display housing.
(3)
Remove engine oil pressure indicator lamps
from printed circuit board.
(4)
Set multimeter to ohms.
(5)
Check continuity through each engine oil
pressure indicator lamp and note reading on
(6)
If continuity is not present, replace engine oil
pressure indicator lamps (para 7-16).
(7)
If continuity is present, replace lighted indicator
display (para 7-16).
(8)
Install engine oil pressure indicator lamps in
printed circuit board.
(9)
Install lamp mounting panel in lighted indicator
display housing.
(10)
Tighten four captive screws in lamp mounting
panel.
(11)
Connect lighted indicator display to connector
PX7.
(12)
Position lighted indicator display in instrument
panel assembly with four screws.
(13)
Tighten four screws to 6-10 lb-in. (1 Nm).
(14)
Connect batteries (para 7-57).
2-529
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals