 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
RESISTANCE TEST
(1) Remove four screws from lighted indicator
display.
(2) Remove lighted indicator display from
instrument panel assembly.
(3) Disconnect connector PX7 from lighted
indicator display connector.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
lighted indicator display connector socket
27.
(6) Connect negative (-) probe of multimeter to
lighted indicator display connector socket
13 and note reading on multimeter.
(7) If 15-25 ohms resistance is not present, go
to step 4 of this fault.
Change 1
2-519
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals