CONTINUITY TEST - TM-9-2320-366-20-10781

TM 9-2320-366-20-1

CONTINUITY TEST

(1)

Loosen four captive screws in lamp mounting

panel.

(2)

Remove lamp mounting panel from lighted

indicator display housing.

(3)

Remove dump up indicator lamps from

printed circuit board.

(4)

Set multimeter to ohms.

(5)

Check continuity through each dump up

indicator lamp and note reading on

multimeter.

(6)

If continuity is not present, replace dump up

indicator lamps (para 7-16).

(7)

If continuity is present, replace lighted

indicator display (para 7-16).

(8)

Install dump up indicator lamps in printed

circuit board.

(9)

Install lamp mounting panel in lighted

indicator display housing.

(10)

Tighten four captive screws in lamp mounting

panel.

(11)

Connect lighted indicator display to connector

PX7.

(12)

Position lighted indicator display in instrument

panel assembly with four screws.

(13)

Tighten four screws to 6-10 lb-in. (1 Nm).

(14)

Connect batteries (para 7-57).

2-493