 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Set multimeter to ohms.
(3) Disconnect connector J31 from connector
P31.
(4) Connect positive (+) probe of multimeter to
connector PX7-12.
(5) Connect negative (-) probe of multimeter to
connector J31-22 and note reading on
multimeter.
(6) If continuity is not present, repair wire 35
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para (7-11).
(7) If continuity is present, repair wire 35
(para 2-45) or replace engine control cable
assembly (para 7-80).
(8) Connect connector J31 to connector P31.
(9) Install instrument panel assembly (para 7-15).
(10) Connect lighted indicator display to connector
PX7.
(11) Position lighted indicator display in instrument
panel assembly with four screws.
(12) Tighten four screws to 6-10 lb-in. (1 N∙m).
(13) Connect batteries (para 7-57).
CONTINUITY TEST
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Set multimeter to ohms.
(3) Disconnect connector J31 from connector
P31.
(4) Connect positive (+) probe of multimeter to
connector J31-10.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If continuity is not present, repair wire 3026
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7) If continuity is present, repair wire 3026
(para 2-45) or replace engine control cable
assembly (para 7-80).
(8) Connect connector J31 to connector P31.
(9) Install instrument panel assembly (para 7-15).
(10) Connect lighted indicator display to connector
PX7.
(11) Position lighted indicator display in instrument
panel assembly with four screws.
(12) Tighten four screws to 6-10 lb-in. (1 N∙m).
(13) Connect batteries (para 7-57).
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals