 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Remove personnel heater assembly for
access (para 18-9).
(2) Disconnect connector P913 from connector
J913.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector P901 socket 1.
(5) Connect negative (-) probe of multimeter to
connector P913 pin 10 and note reading on
multimeter.
(6) If continuity is not present, repair wire 3020
from connector P901 socket 1 to connector
P913 pin 10 (para 2-45) or replace auxiliary
panel cable assembly (para 7-58).
(7) If continuity is present, repair wire 3020
from connector J913 socket 10 to terminal
board TB2 position 31 (para 2-45) or replace
WTEC II dashboard cable assembly (para
7-10) or WTEC III dashboard cable assembly
(para 7-11).
(8) Install personnel heater assembly (para
18-9).
Change 1
2-403
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals