Quantcast VOLTAGE TEST - TM-9-2320-366-20-10639

 

Click here to make tpub.com your Home Page

Page Title: VOLTAGE TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
SPEEDOMETER DOES NOT ILLUMINATE (CONT)
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
VOLTS GAGE DOES NOT ILLUMINATE
TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to connector PX8 socket 2.
(3) Connect negative (-) probe of multimeter to
ground.
(4) Position main light switch main selector
lever to SER DRIVE (TM 9-2320-366-
10-1).
(5) Position main light switch auxiliary lever to
PNL BRT (TM 9-2320-366-10-1).
(6) Position dimmer switch for maximum
brightness (TM 9-2320-366-10-1) and note
reading on multimeter.
(7) If 12 VDC is not present, repair wire 1908
from connector PX8 socket 2 to connector
PX10 socket 2 (para 2-45) or replace
WTEC II dashboard cable assembly (para
7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) If 12 VDC is present, replace speedometer
(para 7-14).
(9) Position main light switch to auxiliary lever
to OFF (TM 9-2320-366-10-1).
(10) Position main light switch main selector
lever to OFF (TM 9-2320-366-10-1).
(11) Connect connector PX8 to speedometer
connector.
(12) Connect connector clamp on speedometer
connector.
(13) Install instrument panel (para 7-15).
Change 1
2-390.13

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.