 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Disconnect connector P921 from connector
J921.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector P921 pin A.
(4) Connect negative (-) probe of multimeter to
connector J39 pin 2 and note reading on
multimeter.
(5) If continuity is not present, repair wire 3028
in troop transport alarm cable assembly
(para 2-45) or replace troop transport alarm
cable assembly (para 20-69).
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J39 socket 1.
(3) Connect negative (-) probe of multimeter to
connector P921 pin C and note reading on
multimeter.
(4) If continuity is not present, repair wire 3028
in troop transport alarm cable assembly
(para 2-45) or replace troop transport alarm
cable assembly (para 20-69).
(5) Connect connector P39 to connector J39.
(6) Connect connector clamp on connector P39.
(7) Lower cab (TM 9-2320-366-10-1).
Change 1
2-379
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals