Quantcast VOLTAGE TEST - TM-9-2320-366-20-10511

 

Click here to make tpub.com your Home Page

Page Title: VOLTAGE TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
REAR BRAKE AIR PRESSURE GAGE DOES NOT OPERATE OR IS INACCURATE (CONT) - TM-9-2320-366-20-10510
Up
TM-9-2320-366-20-1 M1083 Series 5-Ton 6 x 6 Medium Tactical Vehicles (MTV) Manual
Next
REAR BRAKE AIR PRESSURE GAGE DOES NOT OPERATE OR IS INACCURATE (CONT) - TM-9-2320-366-20-10512
TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
VOLTAGE TEST
(1)
Remove instrument panel for access
(para 7-15).
(2)
Disconnect connector clamp from REAR
BRAKE AIR pressure gage connector.
(3)
Disconnect connector PX5 from REAR
BRAKE AIR pressure gage connector.
(4)
Set multimeter to volts DC.
(5)
Connect positive (+) probe of multimeter to
connector PX5 pin 3.
(6)
Connect negative (-) probe of multimeter to
ground.
(7)
Position master power switch to on (TM 9-
2320-366-10-1).
(8)
If 24 VDC is not present, repair wire 1546
from connector PX5 pin 3 to connector
PX4 pin 3 (para 2-45) or replace WTEC II
dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly
(para 7-11).
(9)
Position master power switch to off (TM 9-
2320-366-10-1).
Change 1
2-330.5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.