 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CONTINUITY TEST
(1) Disconnect batteries (para 7-57).
(2) Remove instrument panel assembly for
access (para 7-15).
(3) Disconnect connector J31 from connector
P31.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to connector J31pin 5.
(6) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(7) If continuity is not present, repair wire
3015 from connector J31 pin 5 to terminal
board TB2 position 18 on power
distribution panel (PDP) (para 2-45) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) If continuity is present, repair wire 3015
from connector P31 socket 5 to terminal
lug TL29 (para 2-45) or replace engine
control cable assembly (para 7-80).
(9) Connect connector J31 to connector P31.
(10) Install instrument panel assembly (para
7-15).
(11) Connect batteries (para 7-57).
Change 1
2-315
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals