 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Install relay K26 in PDP.
(2) Remove three screws and washers from
PDP.
(3) Remove three screws from PDP.
(4) Lift PDP outward to gain access.
(5) Set multimeter to volts DC.
(6) Connect positive (+) probe of multimeter to
terminal board TB1 position 36.
(7) Connect negative (-) probe of multimeter to
ground.
(8) Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(9) If 24 VDC is not present, repair wire 1692
from terminal board TB1 position 36 to circuit
breaker CB21 socket 1 (para 2-45) or replace
WTEC III dashboard cable assembly (para 7-11).
(10) If 24 VDC is present, repair wire 1692 from
terminal board TB1 position 34 to relay K26
socket 30 on PDP (para 2-45) or replace
WTEC III dashboard cable assembly (para
7-11).
(11) Position master power switch to off
(TM 9-2320-366-10-1).
(12) Install PDP on dashboard with three screws.
(13) Install three washers and screws in PDP.
(14) Install PDP cover (para 16-2).
Change 1
2-255
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals