VOLTAGE TEST - TM-9-2320-366-20-10361

TM 9-2320-366-20-1

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle. Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

VOLTAGE TEST

(1) Install relay test wire in neutral start relay

socket 30 on VIM.

(2) Install neutral start relay in VIM.

(3) Install circuit breaker CB35 in PDP.

(4) Set multimeter to volts DC.

(5) Connect positive (+) probe of multimeter

to relay test wire.

(6) Connect negative (-) probe of multimeter to

ground.

(7) Position master power switch to on

(TM 9-2320-366-10-1) and note reading on

multimeter.

(8) If 24 VDC is not present, replace neutral

start relay (para 8-6).

(9) Position master power switch to off

(TM 9-2320-366-10-1).

(10) Remove circuit breaker CB35 from PDP.

(11) Remove neutral start relay from VIM.

(12) Remove relay test wire from neutral start

relay socket 30 on VIM.

Change 1

2-231