Removal (M977, M983, M984, M985).

TM 9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-62.

COMPOSITE TAILLIGHT ASSEMBLY REMOVAL/INSTALLATION (CONT).

NOTE

There are three types of rear

composite lights.

Model A has a larger lens than

Model B.

Model C is an LED composite

light and has a ground wire

pigtail.

Removal and installation

procedures are the same for

Model A and B. Not all parts

are interchangeable.

Model B rear composite light

has a printed circuit board for

the blackout marker and the

stop lamp.

Removal (M977, M983, M984, M985).

(1)

Remove four screws (1) and

lockwashers (2) from composite

taillight bracket (3).

(2)

Pull four wires (4) from hole (5) until

four connectors (6) are showing.

NOTE

Tag and mark wires before disconnecting.

(3)

Disconnect four wires (4).

(4)

Push wires (4) back through

connectors (6) and remove four C

washers (7).

(5)

Remove two screws (8), lockwashers (9),

ground wire pigtail (9.1) (Model C only),

and composite taillight (10) from

composite taillight bracket (3).

Change 5