Removal. - TM-9-2320-279-20-10892

TM 9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-61.

FRONT COMPOSITE LIGHT ASSEMBLY REMOVAL/INSTALLATION (CONT).

NOTE

There are three types of front and

rear composite lights. Model A has a

larger lens than Model B. Model C

is an LED composite light. Removal

and installation procedures are the

same for Model A and Model B. Not

all parts are interchangeable.

Model B front composite light has a

printed circuit board for the blackout

marker.

Model C front composite light is an

LED with a ground wire pigtail.

Removal.

(1)

Remove screw (1), washer (2), nut (3),

and clamp (4).

NOTE

Tag and mark wires before disconnecting.

(2)

Disconnect three wires (5) at

connectors (6).

(3)

Push three wires (5) back through

connectors (6) and remove three C

washers (7).

(4)

Soldier A holds front composite light (8)

from outside of cab while Soldier B

removes two screws (9) and

lockwashers (10) (Model C only) and

ground wire pigtail (11) from inside cab.

(5)

Remove front composite light (8) from

outside of cab.

7-218

Change 5