TRANSMISSION POWER TAKEOFF SEAL REMOVAL AND REPLACEMENT (ALL TRUCKS EXCEPT M51A2).

9-2320-211-34-2-3

17-57.

TRANSMISSION POWER TAKEOFF SEAL REMOVAL AND REPLACEMENT

(ALL TRUCKS EXCEPT M51A2).

N o special tools required

TOOLS:

SUPPLIES:

Oil seal

B e a r i n g cap gasket

P E R S O N N E L : One

EQUIPMENT CONDITION:

T r u c k parked, engine off, handbrake set.

P r e l i m i n a r y Procedures.

(1) Remove power takeoff-to-front winch propeller shaft from power takeoff.

R e f e r to TM 9-2320-211-20.

(2) Remove universal joint yoke. Refer to TM 9-2320-211-20.

(3) Drain oil from power takeoff. Refer to LO 9-2320-211-12.

(4) Remove power takeoff from transmission. Refer to para 17-60.

b. R e m o v a l .

FRAME

Takeout four capscrews (1) and starwashers (2).

NOTE

I f front bearing cap (3) is stuck to power take-

o f f housing case (4), tap sides of bearing cap

w i t h soft-faced hammer.

Takeoff front bearing cap (3) and gasket (5). Throw away gasket.

CAUTION

B e careful not to damage front bearing cap (3)

w h e n removing oil seal (6).

U s i n g punch, drive out oil seal (6). Throw away seal.

END OF TASK

17-794