Assembly of Control Valve Bank.

TM 9-2320-211-34-2-3

g. A s s e m b l y o f C o n t r o l V a l v e B a n k .

NOTE

B e sure valve assemblies (6) are put back on

in the same way that they were taken off.

FRAME

P u s h two rods (1) through two upper holes in side plate (2).

Put s l e e v e ( 3 ) , p o p p e t ( 4 ) a n d s p r i n g ( 5 ) i n t o v a l v e a s s e m b l y ( 6 ) .

Put t h r e e metal seals (7) on side plate (2).

Put s p a c e r plate (8) over rods (1) and onto side plate (2).

Put f o u r new large preformed packings (9) and four new small preformed

p a c k i n g s (10) into holes in spacer plate (8).

H o l d spring (5) in place.

P u t valve assembly (6) over rods (1) and onto

spacer plate.

GO TO FRAME 2

17-645