FRAME 2 - TM-9-2320-211-34-2-30341

TM 9-2320-211-34-2-3

FRAME 2

NOTE

B e sure to put wear plates (1 and 2) back in positions

n o t e d in disassembly.

T a p two pins (3) into bores in rear end cover (4).

Press two bearings (5) into bores in rear end cover (4). Refer to Part 1,

para 7-7.

P u t wear plate (1) on pins (3) and push it in place against rear end cover

( 4 ) . Take care not to scratch or nick wear plate.

P u t pump body (6) on pins (3) and push it in place against wear plate

( 1 ) . Notch on pump body must be on same side as notch on rear end

cover (4).

P u t driveshaft assembly (7) and driven shaft assembly (8) into bores

o f bearings (5), taking care not to scratch or nick bearings or shafts.

P u t wear plate (2) on driveshaft assembly (7) and driven shaft assembly

( 8 ) and push it in place against pump body (6). Take care not to scratch

o r nick wear plate.

GO TO FRAME 3

17-325