FRAME 2 - TM-9-2320-211-34-2-10082

TM 9-2320-211-34-2-1

FRAME 2

S p r e a d lubricating oil around oil seal before putting damper and pulley

a s s e m b l y back.

P r e h e a t crankshaft damper and pulley assembly (1) at 200F for 30 minutes.

NOTE

To insure proper seating of crankshaft damper and

p u l l e y assembly, the installation of the heated dam-

p e r and pulley assembly, including installation and

t i g h t e n i n g of retaining screw, should be done as

r a p i d l y as possible before temperature of the pulley

and crankshaft equalize.

S t a r t crankshaft damper and pulley assembly (1) on crankshaft alining

p u l l e y keyway with pulley locator. H e a t e d pulley should slide on

c r a n k s h a f t and seat against deflector.

I f pulley (1) does not seat the right way, take out pulley mounting bolt,

p u t crankshaft damper and pulley reflector in the end of crankshaft.

H o l d replacer bolt (2) while turning plain nut (3) to seat damper and

pulley assembly (1).

T a k e out damper and pulley replacer and pulley locator.

GO TO FRAME 3

2-54