FRAME 2 - TM-9-2320-211-20-3-20742

TM 9-2320-211-20-3-2

NOTE

The top part of boards (1) has clearance around the

screw holes to sink the screw head. The bottom part

of boards does not have clearance around the screw

holes.

1. Find top part of inside boards (1). Put ten screws (2) through holes in each

inside board so screw heads are on top side.

2. Put screws (2) through holes in channels (3). Using socket wrench, screw

on and tighten ten nuts (4) on screws. If screws do not come through enough

to screw on nuts, using mallet, hammer screws in.

GO TO FRAME 3

21-100