 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-20-3-2
c. Adjustment.
FRAME 1
1.
Using 3/4-inch wrench, loosen nut (1).
2.
Using pliers, take out and throw away cotter pin (2). Push out clevis pin
(3).
3.
Using 11/16-inch wrench, unscrew and take off two nuts with washers (4).
Pull tensioner brake chamber (5) back to turn yoke (6).
4.
If tensioner sheaves are too tight, turn yoke (6) toward nut (1). If
tensioner sheaves are too loose, turn yoke away from nut.
5.
Put tensioner brake chamber (5) in place on bracket (7). Aline holes in
yoke (6) with hole in lever (8). Put in clevis pin (3).
6.
Using pliers, put in and bend open ends of new cotter pin (2).
7.
Using 11/16-inch wrench, screw on and tighten two nuts with washers (4).
8.
Using 3/4-inch wrench, tighten nut (1) against yoke (6).
9.
Do checkout procedure again. Refer to para 18-9b.
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals