Assembly of Seat Assembly.

TM 9-2320-211-20-3-2

FRAME 1

Put seven square neck screws (1) through holes in board (2) from top side

of board as shown. Using mallet, tap screws in so heads are flush with

board.

Put angle iron (3) on one screw (1) and put six channels (4) on other six

screws.

Using 1/2-inch wrench, screw on and tighten seven nuts (5).

Do step 1 again for board (6).

Put board (6) in place so six screws go through bottom holes in channels (4)

and one screw goes through bottom hole in angle iron (3).

Put six hinges (7) in place as shown. Using 1/2-inch wrench, screw on and

tighten seven nuts (8).

TO FRAME 2