 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-20-3-2
FRAME 2
1.
Using screwdriver bit, screw in and tighten front plug (1) and rear plug (2).
Back off plugs until screw slot in plugs aline with cotter pin holes in drag
link (3).
2. Using pliers, put cotter pin (4) in each end of drag link (3) and bend open
ends of cotter pins.
3. Put two tabs on each dust shield (5) in slots on other end of dust shield.
Using pliers, pull tabs and bend them back as shown.
NOTE
Follow-On Maintenance Action Required:
Do drag link check and adjustment. Refer to para 14-6d.
END OF TASK
14-19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals