REAR WHEEL BEARING CONES AND SEALS REMOVAL AND REPLACEMENT FOR SERVICE

TM 9-2320-211-20-3-2

13-11. REAR WHEEL BEARING CONES AND SEALS REMOVAL AND REPLACEMENT

FOR SERVICE.

Portable bearing lubricator, NSN 4930-00-704-1852

TOOLS:

Hand grease gun, NSN 4930-00-253-2478

3/4 x 10-inch brass drift pin

Medium ballpeen hammer

SUPPLIES : Artillery and automotive grease, type GAA, MIL-G-10924

Solvent, dry cleaning, type II (SD2), Fed. Spec P-D-680

Clean rags

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked on level ground, engine off, hand-

brake set.

Preliminary Procedure. Remove rear wheels and brake drum assembly.

Removal.

FRAME 1

NOTE

Outer wheel bearing cone and seal are taken out

during rear wheels and brake drum assembly re-

moval.

Working through front of hub (1) and using hammer and brass drift, tap out

wiper (2), seal (3), and inner wheel bearing cone (4).

END OF TASK