 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-20-3-1
c.
Replacement and Adjustment.
FRAME 1
1.
Place air compressor drive belt (1) over air compressor pulley (2) and
crankshaft pulley (3).
2*
Using air compressor pulley adjusting wrench (4), turn adjusting flange (5)
to the right. Keep turning until there is no slack in air compressor drive
belt (1).
3.
Using finger pressure, push on belt (1) at point midway between air
compressor pulley (2) and crankshaft pulley (3). Belt should give at this
point about 3/4-inch.
4.
Turn adjusting flange (5) to the right or the left until belt (1) gives the
--
right amount.
5.
Using 9/16-inch wrench, screw in and tighten two capscrews (6).
NOTE
Follow-on Maintenance Action Required:
Replace fan drive belts. Refer to para 6-12. Close hood.
Refer to TM 9-2320-211-10.
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals