Junction tee fitting. - TM-9-2320-211-20-3-10806

9-2320-211-20-3-1

(b) Junction tee fitting.

CAUTION

Fittings are made of soft brass. They can be

stripped very easily if tightened too much.

Tighten fittings just enough to stop fluid

from leaking.

NOTE

The junction tee on the brake hydraulic line

on the front axle is used for this typical

procedure.

FRAME 1

Put tee fitting (1) in place. Using 7/16-inch open end wrenches, screw on

and tighten screw (2) and nut (3).

2. Using 3/4-inch open end wrench, hold tee fitting (1). Using 7/16-inch com-

bination box and open end wrench, screw on and tighten three tube nuts (4).

NOTE

Follow-on Maintenance Action Required:

Bleed hydraulic system. Refer to para 12-14.

END OF TASK

12-74