Section VIII. ACCELERATOR AND THROTTLE CONTROL

TM 9-2320-211-20-3-1

4-32. ENGINE STOP CABLE REMOVAL, REPLACEMENT AND ADJUSTMENT.

TOOLS: 9/16-inch open end wrench

11/32-inch open end wrench

Cross-tip screwdriver (Phillips type)

SUPPLIES: None

PERSONNEL: TWO

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedures.

(1) Open hood and left side panel. Refer to TM 9-2320-211-10.

(2) Remove main light switch. Refer to para 7-8.

b. Removal.

FRAME 1

Using 11/32-inch wrench and screwdriver, unscrew and take off nut (1) and

lockwasher (2). Take screw (3) out of clamp (4), and take off lockwasher

(5).

2. Take clamp (4) off control cable (6).

3. Using screwdriver, loosen screw (7). Straighten end of control cable wire

(8) and pull it out of swivel (9).

GO TO FRAME 2

TA 054794

4-160