 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-10-4
JACKING
PROCEDURE
NOTE
This task is the same for all wheels. This
task is shown for the left rear-rear wheel.
TOOLS:
Hydraulic screw jack with handle.
Wood block
SUPPLIES:
PERSONNEL:
One
Truck parked, engine off, handbrake set, wheels
EQUIPMENT
CONDITION:
chocked.
WARNING
Never get underneath truck that is held up by
jack only. Jack may slip, causing truck to fall
resulting in severe injury to personnel.
a.
Raising Truck.
FRAME
1
1.
Take hydraulic screw jack (1) and handle (2) out of stowage compartment
above left running board.
2.
Put wood block (3) on the ground under spring seat (4) and put screw jack
(1) on wood block.
3.
Turn out screw jack (1) until it touches spring seat (4).
4.
Using slotted end of jack handle (2), turn bleeder valve (5) to the right. Put
jack handle in screw jack (1).
5.
Moving jack handle (2) up and down, raise wheel assembly (6) off ground.
END
OF
TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals