STATIC DISCHARGE REEL ASSEMBLY MAINTENANCE

TM 55-1730-223-13

3-28. STATIC DISCHARGE REEL ASSEMBLY MAINTENANCE. The Static Discharge

Reel Assembly consists of the reel and attaching hardware, the wires

and the clips. The removal, repair and installation instructions are as

follows:

a. Refer to paragraph 3-29 for removal, repair and installation of

clips.

b. Refer to paragraph 3-30 for removal repair and installation of

static discharge reel.

3-29. REMOVAL, REPAIR AND

INSTALLATION OF CLIPS. (AVUM)

a. Loosen setscrews (1) on

clips (2).

b. Remove clips from wires.

c. Replace damaged clips.

d. Install wires inside clips

(2).

e. Tighten screws.

3-30. REMOVAL, REPAIR AND

INSTALLATION OF STATIC DISCHARGE

REEL.

NOTE

Static Discharge Reel

can be replaced AVUM but

must be repaired at AVIM.

a. Loosen four screws (1). Keep

washers and nuts to use again.

b. Lift static discharge reel

(2) up and away from main frame.

c. Inspect reel for worn or

damaged parts. Replace parts as

needed.

d. Position discharge reel (2)

on main frame. Align holes.

e. Position screws (1) thru

holes in reel and main frame.

f. Secure screws with washers

and nuts.

3-18