FIRST ENGINE START (GPU START)
1. Exterior light switches - As re-
2. Strobe beacon light switch - OFF.
3. Propeller - Clear.
4. Ignition and engine start switch -
ON. Propeller should begin to ro-
tate and associated IGN ON light
should illuminate. Associated
FUEL PRESS light should extin-
If ignition does not occur within 10 seconds
after moving condition lever to LOW IDLE,
initiate ENGINE CLEARING procedure. If
for any reason a starting attempt is discon-
tinued, the entire starting sequence must be
repeated after allowing the engine to come
to a complete stop (1 minute minimum).
5. Condition lever (after N1 RPM sta-
bilizes, 12% minimum) - LOW