Lift crane and align with the crane mounting points.
It may be necessary to adjust one or all of the crane mounting cams (9) if the mounting
points cannot be aligned with the brackets on the chassis (8).
Release the cam mounting bolt (11) by knocking back the lock washer tab (10).
Turn the cam mounting bolt (11) counter clockwise until the cam can be rotated clear of the
crane mounting (7).
Align the crane (6) with the crane mounting points (7).
Insert the crane mounting pins (3).
Fit the crane mounting pin locking plates (4).
Secure the locking plates with bolts (2) and washers. Use thread-locking compound on the
Align the cam (9) with the crane (6).
Tighten the cam mounting bolts (11) and lock in place with the lock washer (10).
Reconnect the five crane hydraulic couplings (5), in the positions noted during removal,
screw on clockwise.
Reconnect the electrical supply cable (1) to the crane.
Reposition and secure the home bank end beam adapters.
Disconnect the lifting device and sling.
Follow on tasks
Switch the battery shutoff switch to the on position.
Operate the crane in accordance with the operator's manual TM 5-5420-279-10.
Check for leaks.