Remove both folding walkway ladders, remove the R-clip in the pivot pin, support the
weight of the ladder, undo and release retaining strap, remove pivot pin, lift ladder clear
replace pivot pin in the ladder replace R-clip in pivot pin. Repeat for other side.
Rotate the A-Frame leg: Press A-Frame rotate deploy button on the interface panel, insert
shoot bolts at position used to hold mudguards on the vehicle.
Remove A-Frame stabilizer leg R clips and pins.
Lower stabilizer legs to the ground using controls at center of A-Frame lower cross-
member, do not apply load to legs.
Remove stabilizer feet, by removing the nyloc nuts and the securing U-bolts.
Raise stabilizer legs using controls at center of A-Frame lower cross-member. Re-insert U-
bolt and nyloc nuts in the feet for safekeeping.
Replace A-Frame stabilizer pins and R-clips.
Rotate the A-Frame down. Remove the shoot bolts, at position used to hold mudguards on
the vehicle, press A-Frame Park button on the interface panel until parked light comes on.
Remove the two A-Frame hinge-locking pins from each side.
Fold the A-Frame legs. Press A-Frame fold park button on interface panel, until parked
light comes on.
Insert the two A-Frame hinge locking pins and R clips on each side.