Tail Lift Re-Fitting

TM 5-5420-279-23

Tail Lift Re-Fitting

To refit the tail lift after transport proceed as follows:

NOTE

The numbers on the figures refer to the paragraph numbers in the procedure.

(1)

Move tail lift into position using fork lift and align pivot holes.

WARNING

INJURY TO PERSONNEL. NEVER USE FINGERS TO PUSH PINS IN OR OUT OF

HOLES. SERIOUS PERSONAL INJURY WILL RESULT IF THIS INSTRUCTION IS

NOT OBSERVED.

(2)

Insert swing arm pivot pins on both sides.

(3)

Insert swing cylinder pivot pins on both sides.

WARNING

INJURY TO PERSONNEL. ENSURE HYDRAULIC AND ELECTRICAL SYSTEMS ARE

SWITCHED OFF WHEN CONNECTING OR DISCONNECTING HYDRAULIC

COUPLINGS AND ELECTRICAL CONNECTORS.

CAUTION

Protect open coupling and plugs against the ingress of dirt during transport,

contamination or damage to plugs and systems may result.

(4)

Connect electrical harness to rear light cluster.

(5)

Re-attach to chassis where appropriate.

(6)

Connect electrical harness to both solenoid valves. Re-tighten center screws in plugs. Re-

attach to chassis where appropriate.

5-473