Locate and identify the upper and lower end wear pads (1) in both sections two and three
of the slide frame.
Remove the upper and lower end wear pad locking plates (2) by removing the four
retaining bolts (3) and lock washers (4) securing them to the slide frame. Discard lock
Repeat operations 2 & 3 on the remaining three sets of end wear pads.
Check each end wear pad (1) and if they are less than 6mm thick replace wear pad.
Examine all components for damage and corrosion.
Examine bolt heads and threads for damage.
Replace components as required.
Insert the end wear pad (1) into the slide frame.
Apply thread locking compound to the retaining bolts (3)
Replace the locking plate (2) and secure with the retaining bolts (3) and lock washers (4).