 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-5420-279-23
a.
Remove
(1)
Depressurize the system in accordance with unit maintenance procedure 5-118.
(2)
Remove the shoot bolt handle (11).
(3)
Disengage the tilt roller support shoot bolts (2 and 3).
(4)
Note the position of and remove the hydraulic connections (6 and 7) to the tilt roller
cylinder. Fit protective caps to the hydraulic connections.
(5)
Note the position of and remove the flexible hoses (19) to the tilt roller assembly. Fit
protective caps to the flexible hoses.
(6)
Remove the bolts and washers (10) securing the keep plate (9) on the tilt roller cylinder
base pin (8).
(7)
Remove the keep plate (9).
(8)
Support the weight of the tilt roller assembly (1).
(9)
Remove the shoot bolt (12).
(10)
Remove the pin (8). With draw the pin (8) from the same side as the keep plate (9).
(11)
Slide the tilt roller cylinder (17) towards the front of the vehicle by three inches.
(12)
Support the weight of the tilt roller support roller (18).
(13)
Remove the top snap ring (16) on the tilt roller cylinder piston pin (13).
(14)
Remove the pin (13).
(15)
Fit the spacers (15 and 14) in the positions noted during removal.
(16)
Remove the tilt roller cylinder (17) from the tilt roller assembly (1) towards the rear of the
vehicle.
(17)
Check all bolt head and threads for damage.
(18)
Check the pins and mountings for damage and wear.
(19)
Replace as necessary.
b.
Install
(1)
Fit the tilt roller cylinder (17) in the tilt roller assembly (1).
(2)
Align the tilt roller support (18) with the tilt roller cylinder piston (17).
(3)
Fit the spacers (14 and 15) in the positions noted during removal.
(4)
Fit the tilt roller cylinder piston pin (13) and fit the snap ring (16).
(5)
Align the tilt roller cylinder in the tilt roller assembly (1).
(6)
Fit the tilt roller cylinder base pin (8).
(7)
Apply thread-locking compound to the bolts (10).
(8)
Fit the keep plate (9) and secure in place with the bolts and washers (10).
(9)
Apply thread-locking compound to the shoot bolt handle (11).
(10)
Fit the shoot bolt (12).
(11)
Fit the shoot bolt handle (11) to the shoot bolt (12).
(12)
Remove the protective caps on the flexible hoses. Fit the flexible hoses (19) to the tilt roller
assembly in the positions noted during removal.
5-281
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals