Remove - TM-5-5420-279-230446

TM 5-5420-279-23

Remove

(1)

The stowing cylinders (1) are located

on the side of the launch frame and are

connected to the articulator cylinder

(2).

(2)

Remove the launch frame guards as

required. Refer to operator's

TM 5-5420-279-10 Chapter 10.

(3)

De-pressurize hydraulic system. Refer

to unit maintenance procedure 5-118.

(4)

If required de-pressurize stow cylinder

refer to unit maintenance procedure

5-123.

(5)

Note the position of and remove the

three hydraulic hoses (3) connected to

the stow cylinder (1).

(6)

Remove the bolts (4) securing the

cylinder locking plate (5)

(7)

Remove the stow cylinder pivot pin (6)

and retain the two spacers.

(8)

Support the weight of the stow cylinder

(1).

(9)

Remove the snap ring (7) from the

stow cylinder pivot pin (8) on the

launch frame mounting.

(10)

Remove the stow cylinder pivot pin (8)

and retain the two spacers.

(11)

Remove the stow cylinder (1).

(12)

Inspect components for damage and

corrosion.

(13)

Examine bolt heads and threads for

damage.

(14)

Replace components as required.

Install

(1)

Position and support the weight of the

stow cylinder (1) on the launch frame

mounting.

(2)

Partially insert the pivot pin (8) through the stow cylinder and fit the spacers.

(3)

Insert the pivot pin (8) and secure in place with the snap ring (7).

(4)

Position and support the weight of the stow cylinder (1) on the articulator cylinder

mounting.

(5)

Partially insert the pivot pin (6) through the stow cylinder (1) and fit the spacers.

NOTE

Locking plate and screws should be fitted towards the centerline of the frame assembly

rather than towards the outside.

5-190 Change 1