 |
|||
|
|
|||
|
Page Title:
Chapter 4. SHIPMENT, LIMITED STORAGE, AND DEMOLITION TO PREVENT ENEMY USE |
|
||
| ||||||||||
|
|
 C2, TM 11-6625-564-12
CHAPTER 4
SHIPMENT, LIMITED STORAGE, AND DEMOLITION TO
PREVENT ENEMY USE
Section I. SHIPMENT AND LIMITED STORAGE
4-1. Disassembly of Equipment
4-2. Repackaging for Shipment and
Limited Storage
Prepare the maintenance kit for shipment
and Storage as follows:
The exact procedure for repackaging de-
a. Disconnect the cables and flexible module
pends on the material available and the condi-
extenders.
t i o n s under which the equipment is to be
shipped (b below) or stored (c below). Adapt
b. Roll up the cables and place them in the
cable storage space provided inside the transit
the procedures outlined below whenever cir-
case.
cumstances permit. The information concern-
c. Place the cable adapters in the bag pro-
ing the original packaging (para 21) will also
vided and place toolkit tools in the bag pro-
be helpful.
vided.
d. Place both bags and the dummy load
a. Material Requirements. The following
i n s i d e the transit case cover (MK-731A/
materials are required for packaging the main-
Place the
ARC-51X), and close the door.
tenance kit for shipment. For stock numbers
dummy load (MK-73l/ARC-51X) in the radio
of materials, consult SB 38100.
set simulator mounting tray.
e. Install the simulator mounting tray in the
space provided on the door.
Material
Quantity
f. Place the rigid module extenders, the
Tri-ply fiberboard box
19 x 19 x 25 inches
alignmcnt fixtures, and the locking block in
Polystyrene blocks
6 x 6 inches, 8 each
Nylon tape
10 feet
the rigidi module extender mounting tray. In-
Barrier, MIL-B-131
17 x 17 x 23inch bag
stall the module extender mounting tray in the
tramsot case and fasten with the screws pro-
vided.
g. Clip the antenna and the air pump to
t h e top of the module extender mounting
tray.
Caution: Be sure the air vent on the end
h. Place the radio set simulator in the space
of the transit case is open prior to packaging
provided in the transit case. Fasten the radio
for air shipment.
set simulator in place with screws provided on
the radio set simulator.
c. Packaging for Limited Storage. T h e
i. Place the test unit in the space provided
transit case provides adequate protection for
in the transit case. Fasten the test unit in place
the other components of the maintenance kit
with the screws provided.
during limited Storage. The case is corrosive-
j. Place the cover on the transit case lower
resistant and is sealed by a rubber gasket
half.
which makes the case interior airtight and
k. Secure the four twist-lock clamps located
moistureproof, with the air vent closed.
on the sides of the transit case.
Section Il. DEMOLITION OF MATERIEL TO PREVENT ENEMY USE
from using or salvaging this equipment. Dem-
4-3. Authority for Demolition
olition of the equipment will be accomplished
The demolition procedures given in para-
graph 4-1 will be used to prevent the enemy
only upon the order of the commander.
33
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals