CONDITION lever (after N1 RPM passes 13% minimum)

TM 1-1510-223-MTF

PROCEDURE

TROUBLESHOOTING

REFERENCE

FIRST ENGINE START (BATTERY START) (CONT)

CAUTION

If ignition does not occur within 10 seconds after moving

CONDITION lever to LOW IDLE, initiate Abort Start

procedure. If for any reason a starting attempt is discontinued,

the entire starting sequence must be repeated after allowing

the engine to come to a complete stop (1 minute minimum).

CONDITION lever (after N1 RPM

passes 13% minimum) - LOW IDLE.

CAUTION

Monitor TGT to avoid a hot start. If there is a rapid rise in

TGT, be prepared to abort the start before limits are exceeded.

During starting, the maximum allowable TGT is 1000 for 5

seconds. If this limit is exceeded, initiate Abort Start

procedure and discontinue start. Enter the peak temperature

and duration on DA Form 2408-13-1.

TGT and N! (TGT 1000 Maximum).

Oil pressure - Check (60 PSI minimum).

# 2 ENG START switch - OFF after TGT peaks.

10. CONDITION lever - HIGH IDLE.

Monitor TGT as CONDITION lever is

advanced.

11. # 2 GENERATOR switch - RESET, then ON.

2-34